Wika CPC6000 Instrukcja Użytkownika Pobierz pdf (Strona 57)

Automated Pressure Calibrator

CPC 6000

Mensor/WIKA Operating Instructions - CPC 6000 57

118 StableWin {%fs value} Sets the stable window as a %FS.

119 StableWin? <sp>{value}<cr><lf> Returns the stable window in % of Span.

120

Standby none Instrument placed in Standby mode, all sole-

noids de-energized.

121

Standby? <sp>{Yes or No}<cr><lf> Returns YES if the active channel is in Standby,

NO if otherwise.

122

Step <sp>{value inside upper and

lower limits and inside the

range of the active sensor

and turndown}<cr><lf>

Sets the control step size for the instrument.

123

Step- {none or value} Jogs the setpoint down one step. If a value is

entered, sets the step size to that value.

124

Step+ {none or value} Jogs the setpoint up one step. If a value is en-

tered, sets the step size to that value.

125

Step? <sp>{value}<cr><lf> Returns the control step for the instrument.

126

Stop none Stop repeating output over serial port. See:

Repeat

127

Units {units code, or output format

text from Measurement Units

Table 11.1 in the Appendix

Section}

Sets the instrument engineering units.

128

Units? <sp>{string}<cr><lf> Returns the instrument units in a text string.

129

Unlock none Releases Acquire locks. See: Acquire? and

Release?

130

UpperLimit {Value inside primary trans-

ducer range}

Sets the upper control limit for the active chan-

nel.

131

UpperLimit? <sp>{value}<cr><lf> Returns the upper control limit for the active

channel.

132

Vent none Instrument placed in Vent mode.

133

Vent? <sp>{Yes or No}<cr><lf> Returns YES if active channel is in Vent mode,

No if otherwise.

134

Versions? <sp>{string}<cr><lf> Returns the versions of the firmware for the

instrument, gpib driver, gate array, installer, and

the graphics library.

135 Volume {value in cc} Sets the system volume in cc’s – only applicable

if the active channel is a low pressure regulator.

136

Volume? <sp>{value}<cr><lf> Returns the current system volume in cc’s – only

applicable if the active channel is a low pressure

regulator.

137

Zero {desired pressure or ?} Sets active sensor and turndown’s zero to en-

tered pressure, or ? to clear previous value. (See

“Caldisable” command above ref# 19)

138 Zero? <sp>{value}<cr><lf> Returns zero offset value for active sensor and

turndown.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 103 104

Komentarze do niniejszej Instrukcji

Brak uwag

Wika CPC6000 Instrukcja Użytkownika Strona 57

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Urządzenia pomiarowe Wika CPC6000