Wika CPC6000 Instrukcja Użytkownika Pobierz pdf (Strona 55)

Automated Pressure Calibrator

CPC 6000

Mensor/WIKA Operating Instructions - CPC 6000 55

75 Peakmax? <sp>{value}<cr><lf> Returns the maximum pressure since peakreset

was sent.

Peakmin? <sp>{value}<cr><lf> Returns the minimum pressure since peakreset

was sent.

77 Peakreset none Resets the peak values.

Port {value} Sets the Ethernet port of the instrument.

Port? <sp>{value}<cr><lf> Returns the Ethernet port of the instrument.

80 Precision none Sets the active channel to the precision mode:

.003% stablewindow and 4 second stabledelay.

81 Ptype {Absolute or Gauge or A or G} Sets the instrument pressure type – non-native

type only works if the optional barometric sen

sor is installed.

Ptype? <sp>{Absolute

orGauge}<cr><lf>

Returns “Absolute” or “Gauge” for the pressure

type.

RangeMax? <sp>{value}<cr><lf> Returns the maximum range of the active trans-

ducer and turndown in the current units.

RangeMin? <sp>{value}<cr><lf> Returns the minimum range of the active trans-

ducer and turndown in the current units.

Rate? <sp>{value}<cr><lf> Returns the rate reading of the instrument in

current units/second.

86 Rdecpt? <sp>{value}<cr><lf> Returns the number of rate decimal points for

the active channel. See: Resolution

Reference {EXTVAC or ATM} Sets the reference type for vacuum pump

connected to the reference, or vented to atmo

sphere. This option is only available on native

gauge units.

88 Reference? <sp>{EXTVAC or

ATM}<cr><lf>

Returns the current reference type of the active

channel. See: Reference

89 Release? {15 char string} Returns: <sp>(YES or NO), {string}<cr><lf>

This command is used to release control of the

instrument when it is accessed by more than

one computer. To release control of the instru

ment, {string} must be identifier used for the

“Acquire” command. Yes if release is successful.

No if instrument is being controlled with another

computer. Return {string} = identifier of the con

trolling computer or AVAILABLE. See: Acquire?

and Unlock.

90 Repeat None Repeats output continually over serial port only.

91 Resolution {4 to 6} Sets the number of significant digits. See: decpt

Resolution? <sp>{value}<cr><lf> Returns the number of significant digits.

Rsetpt {value} Sets the rate setpoint of the active channel in

current units per second. Must be a value inside

the current sensor range.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 103 104

Komentarze do niniejszej Instrukcji

Brak uwag

Wika CPC6000 Instrukcja Użytkownika Strona 55

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Urządzenia pomiarowe Wika CPC6000