Wika CPC6000 Instrukcja Użytkownika Pobierz pdf (Strona 63)

Automated Pressure Calibrator

CPC 6000

Mensor/WIKA Operating Instructions - CPC 6000 63

7.4.7.3 SCPI Commands

STATus :

OPERation

:CONDition? Returns an integer value representing instrument status

that can be decoded.

Bit 0: Zeroing active.

Bit 1: Control Setpoint has not been reached.

Bit 2: Reserved 0.

Bit 3: Reserved 0.

Bit 4: Measuring. The instrument is actively measuring.

MEASure

[:PRESsure] [z]? Returns the pressure from the active sensor, or active

sensor if [z] is omitted.

:TEMPerature[z]? Returns the temperature in deg. C. from the specified sen

sor, or active sensor if [z] is omitted.

:RATE[z]? Returns the pressure rate from the specified sensor, or ac

tive sensor if [z] is omitted.

:BAROmetric? Returns the barometric pressure, if a barometer sensor is

installed.

CALibration

:MODE? Returns 1 if the sensor has been calibrated or 0 if not.

:DATE? Returns the stored calibration date.

:DATE <i,i,i> Sets the calibration date (YYYY,MM,DD).

:ZERO? Returns current zero point correction.

:ZERO <n> Sets the zero so the currently measured pressure matches

the commanded value. Limited to +/-5% FS.

ZERO:RUN Vents the instrument and sets zero so the currently mea

sured pressure = 0.

SENSE

[:PRESsure] [z] Selects the sensor to read or modify or active sensor if [z]

is omitted.

:NAME? Returns the accuracy and range of the sensor.

:MODE? Returns pressure type “ABSOLUTE” or “GAUGE”

:MODE ABS/GAUGE Sets the pressure type to absolute or gauge.

:ABS? Returns native sensor type “1” for absolute, ”0” for gauge.

:RESolution? Returns the FS-related relative resolution of the sensor.

:RANGE

[:UPPer]? Returns the maximum range of the primary sensor.

:LOWer? Returns the minimum range of the primary sensor.

:Unit

[:NAME]? Returns a string representing the native units of the sen

sor.

:VALue? Returns the conversion factor of the native units of the

sensor.

:REFerence

[:HEIGht] <n> Sets the head height correction [mm].

:MODE? Returns head correction mode - “OFF”, “GAS”, LIQUIT”.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 103 104

Komentarze do niniejszej Instrukcji

Brak uwag

Wika CPC6000 Instrukcja Użytkownika Strona 63

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Urządzenia pomiarowe Wika CPC6000